![]() Please ensure you review the temperature setpoints for your use case to ensure your hard drives are kept at your desired temperature, change the setpoints as needed. There is no warranty provided and you use this scrip at your own risk. With non-RAID, the temperature of the hard disk drives is not monitored, which causes the fan speed to be higher to ensure sufficient cooling resulting in higher noise level RAID Setup with PERC H310: A system configured as non-RAID has a higher noise level than a system configured as RAID. Directly from page 30 PowerEdge T320 Technical Guide This is as designed by Dell, which sucks. The tower servers T320, T420 & T620 inlet temperature sensor is after the HDDs so temperature will be higher than the ambient temperature.Īs you may have discovered, when you cross flash a Dell H310 raid controller to IT mode and as soon as the iDRAC detects that a drive has been inserted the fans spin up and get loud even when the ambient temperature is low, say 20deg C. If monitored temperature is below 35deg C set fan control to manual and set fan speed to predetermined value. If the monitored temperature is above 35deg C enable iDRAC dynamic control and exit program. A simple script to control fan speeds on Dell generation 12 PowerEdge servers.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |